Candle KLVHSKONCT GC32-9172-00 - Manual (Page 102)

102 Candle Products Messages Manual (KLVHS–KONCT)
KLVST040 WARNING: NO STORAGE FOR SOME LSR HIPERSPACE POOLS
Explanation: A BLDVRP macro was issued to allocate a VSAM local shared
resource buffer pool in Hiperspace, but there was not enough Hiperspace™
storage (BLDVRP returned X’2C’).
System Action: CT/Engine continues, using virtual storage for the buffer
pool(s) that could not be allocated in Hiperspace.
User Response: Refer to IBM’s Macro Instructions for Data Sets for the
BLDVRP return code X’2C’.
Message Type:
LOG.
KLVST041 ERROR INITIALIZING SYSMDUMP DATASET
Explanation: An OPEN macro was issued to initialize the SYSMDUMP dataset,
which produced a non-zero return code. Refer to the accompanying IEC141I
message for details on the OPEN failure.
System Action: CT/Engine terminates with a U0012 abend.
User Response: Refer to IBM’s Planning: Problem Determination and
Recovery
for details on pre-allocating SYSMDUMP datasets.
Message Type: ALERT.
KLVST042 SPLEVEL NOT MATCHED, ASSUMING assume. SYSTEM SPLEVEL
DETECTED=level
Explanation: CT/Engine was unable to match the SP level of the current
operating system (level) with an entry in its internal table of supported operating
systems.
System Action: CT/Engine assumes the SP level is assume. Execution
continues.
User Response: Contact Candle Customer Support with the contents of this
message.
Message Type:
LOG.
KLVST043 UNABLE TO OPEN RKANPAR DATASET
Explanation: An OPEN macro was issued to initialize the RKANPAR dataset,
which produced a non-zero return code. Refer to the accompanying IEC141I
message for details on the OPEN failure.
System Action: CT/Engine terminates with a U0012 abend.
User Response: Correct the problem and restart CT/Engine.
Message Type:
ALERT.
KLVST044 LOADLIST MEMBER NOT FOUND IN RKANPAR DATASET
(membername)
Explanation: A FIND macro issued to locate the named LOADLIST member in
the RKANPAR dataset produced a failing return code.
System Action: CT/Engine terminates with a U0012 abend.
User Response: Specify a valid member name and restart CT/Engine.
Message Type:
ALERT.