Philips CCX134AT - Manual (Page 8)

8 Turning On theTV/VCR
Before you turn on theTV/VCR, make sure there are batteries in
the remote control (details are on page five) and theTV/VCR is
hooked up correctly (details are on pages six - seven).
The instructions on this page work only when you turn on the
TV/VCR for the first time.
Press the COMBI button, then the POWER button. The
TV/VCR will come on and the language select display screen
shown below will appear.
SELECT LANGUAGE
1 ENGUSH OK
2 ESPAÑOL
MAKE SELECTION OR
' PRESS EXrTTO CONTINUE
Press the Number I button to select English on-screen
displays or press the Number 2 button to select Spanish
on-screen displays.
Press the STATUS/EXIT button. The channel program display
screen shown below will appear.
/OC№ECrANlB'!NAORCiVSLE
{
Tn
TOTVCR
TUBJ PRESS+
TO END PRESS EXIT
4
Press the Fast Forward/Search/+ button to begin auto­
matic channel programming, AUTO SET PROCEEDING will
appear on-screen.The TV/VCR will place all of the channels you
receive into its memory, so when you scan through channels using
the CH(annel) Up/Down buttons, you’ll only scan through chan­
nels that you receive-When channels are programmed, CHAN­
NELS ARE SET will appear on-screen briefly.Then theTV/VCR will
go to the lowest channel programmed.
(If you try to program channels when there is no antenna or cable
connected to theTV/VCR, programming will appear to take place,
but eventually a NO TV SIGNALS ... message will appear on­
screen. Connect an antenna or cable to theTV/VCR, then try
again.You may need to follow the steps on pages nine - 11
instead.)
Now, you may use the CH(annel) Up/Down buttons or the
Number buttons on the remote control to select a TV/VCR chan­
nel- Use the VOL(ume) Up/Down buttons to adjust the sound.
pD CD DT
HD
j>« tii-tr
(0)0 0 0
PH1UPSCES23
k_____ J
Helpful Hmts
If you do not see any on-screen dis­
plays when you turn on the TV/VCR,
check your hook-ups, then try again.
If you stf// do not see any on-screen
displays, follow the steps on poges
nine - I { to select a language and
program channels.
To skip this feature and play a tape
immediately, insert a tape with Us
record tab removed. Playback will
begin. Or, to skip step 2, press the
STATUS/EXIT button before pro­
ceeding. AH on-screen displays will be
In English.To skip step 4, press the
S7ATLfS/£X/T button before pro­
ceeding. Channels wili not be pro­
grammed, and CHANNELS NOT
SET will appear on-screen briefly.
You cannot program channels if you
are using a Cable Box,
Line Input mode will alv/ays be
stored in theTV/VCR's memory as
channel 00. When you select chan­
nel 00,A/V IN will appear on-screen
briefly. Press the CH(annel)
Up/Down buttons or Number but­
tons to select another channel.