Philips CCX134AT - Manual (Page 30)

30 On-Screen Status Displays
A status display, which includes the current time, channel, and
other information (see illustration of the status display at right),
will appear when you press the STATUS/EXIT button or certain
function buttons.You can bring up the status display at any time by
pressing the STATUS/0OT button. Remove the status display by
pressing this button again.The contents of the status display may
vary.
ON NODE:
o Whenever a function button (Rewind/Search/-, Play/A, etc.) is
pressed, the status display will appear for five seconds.
COUNTER ONLY NODE:
o When a function button (Rewind/Search/-, Play/A, etc.) is
pressed, the status display will appear for five seconds. After five
seconds, only the counter will remain on-screen.To remove it,
choose ON or OFF in the ON-SCREEN MODE menu. (There is
an exception. When you press the Stop/V button, the status dis­
play will appear for five seconds, then disappear.)
OFF MODE:
o The status display will not appear when you press a function
button.The channel number will appear briefly when you select
a channel if channels are programmed.
To choose an ON-SCREEN MODE, follow the steps below.
Press the COMBI button, then the NENU button to dis­
play the pop up menu.
Channel
Time
Function
Button
Pressed
LiC 0AM ST<
L
Tape Counter
Speed and
Counter
Memory
SUP M 1:23:45 Bannoainn^
The current tape
position during fast-
forwarding or
rewinding of a tape
Press the Play/A button or the Stop/7 button to select
VCR SETUP.Then, press the Fast Forward/Search/'P but­
ton.
Press the Number 3 button to select ON-SCREEN
MODE.
4
Press the Number I button to select ON, the Number 2
button to select COUNTER ONLY, or the Number 3 but­
ton to select OFF. Your selection will appear on-screen.
Press the STATUS/EXIT button.
Hmts
- If the channel you select has no
broadcast, the screen v/ili be solid
b/ue.The screen v/ili remain blue
until you select an active channel.
»
Channel numbers (when tuned)
appear on-screen for a few seconds.
“ The channel number
will remain on­
screen at all times (except during
tape playback) if PiEMlNDER is set
to ON. Details are
on poge 3/.
* You cannot view closed captions of a
tape when the JV/VCR is in Counter
Only mode.The counter display will
replace the closed captioning display
on the TV/VCR screen. Details are
on pages 46 - 47.