Timer recording (cant’d) 37 – Philips CCX134AT User Manual
Page 37
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Timer Recording (cant’d) 37
Use the Number buttons (I - 8) to select a position in
which to store the timer recording. Flashing numbers indi
cate an open position (one in which a timer recording has not yet
been stored).
NOI&
if you select a number that has already been used to store a
timer recordings PREVIOUSLY SET PROGRAM will appear on-screen for a
few seconds. Then information about the program in that position wilt
appear on-screen. If this happens, press the
SWUS/HX/T button. Then
use the Number buttons
to select another position.
o Enter the channel of the TV program you want to record (you
must enter a 0 before all single-digit channels),
o If you are recording from line input, press 0,0. A/V IN will
appear on-screen.
o If you are recording using a Cable Box or Satellite System, enter
the Cable Box/Satellite System output channel (03 or 04). Be
sure to select the channel at the Cable Box/Satellite System and
leave the Cable Box/Satellite System on for the timer recording.
You may only program timer recordings for one channel at a
time.__________
/ONETIME PROGRAM ^
PROGRAM I
CHANNEL —
TO CORRECT PRESS CLEAR
TO END PRESS EXIT
Press two Number buttons for the hour(s) you want the
recording to begin. Press two Number buttons for the
minute(s) you want the recording to begin. Press I for AM
or 2 for PM. For example, for 9:30 PM, press 09,30,2.
ONETIME PROGRAM
PROGRAM I
CHANNEL to
TIME ON —;—
TO CORRECT PRESS CLEAR
TO END PRESS EXIT
Follow the instructions in step 6 to set the recording's
stop time. (AM or PM will be set automatically.)
■^ONETIME PROGRAM
PROGRAM 1
CHANNEL 10
TIME ON 09:30 PM
TIME OFF —:—
TO CORRECT PRESS CLEAR
TO END PRESS EXIT
Helpful Hints
If the
numbers entered
do
not
match the TV/VCR’s internal calen
dar, the entry will be rejected and a
question mark (?) will appear on
the TV/VCR screen.
To make corrections while you are
programming a
timer
recording,
press the
Ci-EAR button
until the
cursor is flashing on the item you
want
to
change.Then
enter the
cor
rect information.