Philips CCX134AT - Manual (Page 57)

Helpful Hints (cant’d) 57
A power failure occurred.
^ Follow the steps on pages 8 - 10 to select a language and program channels, if necessary.Then set the
clock (pages 12- 17).
TV/VCR power shuts off after IS minutes.
« To save energy, the TVA^CR will shut itself off after 15 minutes when it is on a channel that is not receiv­
ing a broadcast signal (for example, a station that has gone off the air for the night).This is normal.
Channel reception is poor.
« Check connections, then program channels again (page 10).
TV/VCR does not have a picture.
• Adjust the antenna (pages six - seven).
" Connect the antenna or cable directly to the TV/VCR.
• Adjust the TV/VCR picture controls (page 26).
TV/VCR has poor sound or no sound.
« Adjust the volume.
« Press the MUTE button to restore the volume.
Tape playback is poor or tape is destroyed.
• Adjust the tracking. Detoi/s ore on page 53.
“ If moisture has accumulated in your TV/VCR, keep the power on for at least two hours, but do not try
to play a tape. Details are on page 56.
TV/VCR does not display closed captioning.
• Cancel Counter Only mode. Deto/fs are on page 30.
• Make sure closed captioning is available for the program. Refer to the TV listings in your local newspaper.
Remote control does not operate the TV/VCR.
• Aim the remote control directly at theTV/VCR's remote sensor. Deioi/s
are on pages five and
22.
" Remove all obstacles between the remote control and the TV/VCR.
• Inspect and replace the batteries in the remote control. Detai/s
are on page five.
• Press the COMBI button, then try the other TV/VCR function buttons.
Number buttons won’t work for channels above 69.
■> Select CABLE from the INPUT section of the pop up menu, then lettheTV/VCR program the channels.
Details are on page 10.
TV/VCR can’t receive channels above 13.
“ Select CABLE from the INPUT section of the pop up menu, then lettheTV/VCR program the channels.
Detoi/s ore on page / 0.
A tape can’t be inserted into the TV/VCR,
• If die TV/VCR is turned off for a timer recording, you can not insert a tape that is missing a record tab.
“ Insert the tape window side up, with the record tab facing you.
• Make sure a tape isn’t already in the TV/VCR by pressing the STOP/EJECT button on the TV/VCR.
® Gently push on the center of the tape. Never force a tape into the TV/VCR.
A tape can’t be removed from the TV/VCR.
• Make sure the power plug is completely connected to an AC (alternating current) outleL
• If a timer recording is programmed, turn on the TV/VCR power, dien eject the tape. Be sure to insert a
tape and turn off the TV/VCR power for the timer recording.
TV/VCR ejects the tape when you try to start a recording.
" Make sure the tape has a record tab. Detai/s
are on page five.
The cylinder rotates when the TV/VCR is in Stop mode.
• To enable the quick play mechanism, the cylinder will rotate for about five minutes.This is normal.
Daylight-Saving Time
• When Daylight-Saving Time is ON, the clock time will change automatically as follows: on the first Sunday
of April, from 2 a.m.to 3 a.m.;on the last Sunday of October, from 2 a.m.to 1 a.m.
“ During the April time change, a timer recording programmed to start between 2 AM and 3 AM will not
record. A timer recording programmed to end between 2 AM and 3 AM will end when the clock moves
forward (2 AM).
• During the October time change, a recording cannot be started between the second I AM and 1:59 AM.