Plus, System, 42 timer recording with the vcr – Philips CCX134AT User Manual
Page 42: Programming
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Follow the steps below to program a timer recording using the
PlusCode programming numbers in your TV guide. Before you
begin, make sure:
o The clock has been set. If not, CLOCK MUST BE SET appears,
o Channels are programmed.
o There is a tape In theTVA^CR (make sure the tape’s record tab
is intact and the tape is long enough to record the program),
o You have completed the steps on pages 4 0 - 4 1
Complete each step within 60 seconds of completing the
previous step. If you don% you may return to step I.
42 Timer Recording With the VCR
Plus*
Programming
System
Press the COMBI button, then the VCR PLUS+/ENTER
button on the remote controI.The on-screen display shown
below will appear.
/va
VCR PLUS+ PROGRAM
PLUS CODE:
. TO END PRESS EXIT
Press the Number buttons to enter the PlusCode pro
gramming number of the program you wish to record (this
number is different for every program, and it can be three to eight
digits long). Finally, press the VCR PLUS+/ENTER button.
/vCR PLUS+ PROGRAM
Л
PLUS CODES 60590--------
TO SET PRESSVCR +
TO CORRECT PRESS CLEAR
Что END PRESS EXIT
J
To record the program once, press the Number I button
to select ONCE. To record the same program every day
from Monday through Friday, press the Number 2 button
to select DAILY. To record the same program every week
on the same day (such as every Saturday), press the
Number 3 button to select WEEKLY.
/CR PLUS* PROGRAM
^
1 ONCE
2 DAILY (MON - FRI>
3 WEEKLY
TO SELECT PRESS NUMBER
TO END PRESS EXIT
Hinis
“
If the power fails, programmed timer
recordings will be lost Setting the
clock will restore the timer recording.
® Vbu
cannot set a
timer
recording if
the TVIVCR is in Record Defeat
mode.To
set
the Record Defeat
mode to OFF, see page 44.
“
If CODE ERROR flashes after you
enter the PlusCode programming
number and press the VCR
PLUS+JENTER
button, the number
you entered
was incorred (for exam
ple, too short). If this happens, enter
the correct number.
«
CLASH may flash on the screen after
you conrtplete step 2. This means
that the timer recording you just pro
grammed and another timer record
ing overlap, and thus the current
timer recording will not be carried
out