Philips CCX134AT - Manual (Page 55)

Spedpcations I Glossary
55
Specifications
General
CRT: 13-inch in line gun
Television system: NTSC-M
Closed caption system: Section 15.119, FCC
(Federal Communications Commission) Standard
Video Heads: Four heads
Tape width: 1/2 inch (12.65 mm)
Tape speed
SP: 33.35 mm/sec.
LP:! 6.67 mm/sec.
SLP: 11.12 mm/sec.
OperatingTemperature:4rF (5“C) to KM'F (40°C)
Relative Humidity: 10% to 75%
Power requirement;AC 120V, 60Hz
Power consumption: 75W
Sound output: IW
Dimensions:
15-13/16" (H)
X
15-3/16" (W)
X
14-3/4" (D)
402 mm x 386 mm x 375 mm
Weight: 27.5 lbs (12.5 kg)
Tuner Broadcast Channels
VHF2-I3,UHF 14-69
CATV Channels
Midband:A - I
Superband:J -W
Hyperband:A-5 -A-1
Special Channel: 5A
Ultraband: 37 - 94, 100-125
Terminals
Antenna IN:VHF/UHF 75 ohms unbalanced
Video IN: RCA connector
Audio IN: RCA connector
Earphone: 3.5 mm CES
Electrical Specifications
Video input level: 0.5-2,0Vp-p
Audio input level:-I0dBv
Video S/N ratio
SP; More than 42dBp
Audio S/N ratio
SP: More than 38dB
Designs ond spec/f/catlons are subject to change without
notice and without our legal obligation.
Glossary
AUDIO lack: jack located on the front of the
TV/VCR which is used to record audio from another
source.
Automatic Channel Programming: process in
which the TV/VCR scans all available channels and
places the ones you receive in its memory.Then,
when you push the CH(annei) Up/Down buttons,
you only scan through channels you receive.
Bands: settings that allow you to tune channels.
« Antenna -VHF (very high frequency: channels 2 -
13) and UHF (ultra high frequency: channels 14 -
69).
* Cable “ all standard channels can be received
without a Cable Box.
Brightness: adjusting increases or decreases the
brightness of the color on-screen.
Cable Box/Satellite System Output Channel:
03 or 04.
Color adjusting pales or brightens the TV/VCR color.
Dubbing: copying a tape using a VCR or camcorder.
HQi high quality; a feature in the TV/VCR circuitry
which provides enhanced piaure detail.
Line Input: The channel to which you set your
TV/VCR during dubbing.The line input channel is
always channel 00 (A/V IN).
Mode: a TV/VCR operation.
OTR: one touch recording: programming a timed
recording that starts immediately and records for 30
minutes to eight hours, whichever you specify.
Picture: adjust to increase or decrease the contrast
of the picture on-screen.
Sharpness: adjusting softens or clarifies the picture
on-screen.
Tape Speeds: how fast the tape travels during play­
back or a recording.
" SP (standard play) - festest tape speed (recording
time for aTI20 tape is approximately two hours):
best picture quality.
« LP (long play) - average tape speed (recording
time for aTI20 tape is approximately four hours).
SLP (super long play) - slowest tape speed
(recording time for aT120 tape is approximately
six hours).
Tint: adjusting changes the tints of the piaure on the
TV/VCR from purple to green.
VIDEO lack: jack located on the front of the
TV/VCR which is used to record video from another
source.