Philips CCX134AT - Manual (Page 41)

Setting Up the VCR Plus* Programming System (confd) 41
Examine die lists on
page 40.
Now, compare the channel numbers you have written in theVCR
PLUS-i* CH.and CABLE/TV CH. columns,You’ll notice that some
stations have VCR Plus+ and Cable/TV channel numbers that are
the same, and other stations have channel numbers that do not
match.Where the channel numbers DO NOT match, you must tell
theTV/VCR the VCR Plus+ and Cable/TV channel numbers
according to the following steps.
O Make each entry within 60 seconds of the previous entry. ^
Press the COMBI button, then the MENU button to dis­
play the pop up menu.
4
Press the Play/A button or the Stop/T button to select VCR
SETUP, then press the Fast Forward/Search/+ button.
VCR SETUP
1 ONETIME PLAY ION]
2 RH>EAT PLAY
3 ON-SCREEN MODE
4 RECORD DEFEAT [OFF]
5 VCRPLUS+ RERMAP
TO SELECT PRESS NUMBER
TO END PRESS EXIT
Press the Number 5 button to select VCR PLUS+ REF. MAP.
VCR PLUS+ CROSS RER MAP
VCR PLUS+ CABLETTV
124
125
01 --------------- ► —
02
03
TO SELECT CH PRESS CH A/T
THEN ENTER CH NO.
, TO END PRESS EXIT
a
Look at the lists you filled in on page 40. For stations whose VCR
Pius+ and Cable/TV channels do not match, press the
CH(annel) Up/Down buttons until the arrow Is beside the
VCR Plus+ channel you need.Then, press the Number but­
tons to enter the corresponding Cable/TV channel from
your list. (Enter a “0” before single-digit channels.) Continue this
process until you have entered all the stations on your list.
VCR PLUS+CROSS REF. MAP N,
VCRPLUS+ CABLETTV
124
125
01 ----------► 23
02
03
TO SEUCr OH PRESS CH AJY
TO DELETE PRESS CLEAR
TO END PRESS EXIT
7
Press the STATUS/EXIT button to exit.
□D CD CD!
I
CD (U CD"
m CO CD;
1 100| I 0 I
nVTTH UM» (K10
o o o o
PHILIPS EEIE3
C_J
Helpful Hints
• To correct a Cable/TV channel num­
ber, repeat the steps on this page.
“ To
clear a Cable/TV channel num­
ber, repeat steps 3-S on this page.
Then, press the CH(annel) Up/Down
buttons to select It.Then press the
CLEAR button. Press the
STATUS/EXIT button to
exit
“ Always enter a "0” before single-digit
channels.
“ To
select line input for the Cable/TV
channel, press 0,0. AiV IN will
appear on-screen.