FingerTec TCMS V2 - Manual (Page 17)

17
Voice - Enable or disable the terminal’s voice
1:N threshold - Specify the value for one-to-many matching threshold, where you don’t
need to key in your ID before scanning your finger.
The value equivalent to the quantity of fingerprint’s minutiae points being read during
verification.
Value Range: 0-50, Default Value: 35
1:1 threshold - Specify the value for one-to-one matching threshold, where you have to
key in your ID before scanning your finger.
The value equivalent to the quantity of fingerprint’s minutiae points being read during
verification.
Value Range: 0-50, Default Value: 15
Only 1:1 - Specify the verification matching method preferred for the terminal. Choosing
Yes would require employees to key in their ID number prior to scanning a fingerprint.
Choosing No , the terminal will adopt 1:N matching method.
Idle Minute - Specify the minute value before the terminal turns idle. When the terminal is
left uninterrupted for this value of time, the terminal will either power off or go into sleep
mode. Choose
0 if you want to disable this function.
Idle Action - Choose between Sleep Mode / Power off to decide on the action of the termi-
nal after it exceeds its idle minute period.
Lock Delay - Specify the timer of the door lock after any successful verification is done and
before the door is locked again. Maximum Value: 254, Default Value: 150
Wiegand Format - Specify the Wiegand bits of the terminal. Select between 26 or 34
Anti-passback - Choose the anti-passback value. Anti-passback is exclusively for door ac-
cess function where a user will be denied exit if there is no record of entry. Default value: None,
Other options: Out, in, in out, no and save
Baudrate - Choose the data transmission speed for COM communication for RS232/RS485
Connection. Default Value: 115200
IP Address - Specify the IP address of the terminal. Only applicable for TCP/IP connection.
Default Value: 192.168.1.201
Connection - Choose from the type of connection available.
Communication Key - Specify the communication key of the terminal and the value must
match with the value in the terminal. Default Value: 0
Sleep Time - Specify the time for the terminal to be in idle mode.
Power off Time - Specify the time for the terminal to shut down automatically.
Power On Time - Specify the time for the terminal to be turned on automatically.
SDK Version - Display the SDK Version of the terminal
Firmware Version - Display the Firmware Version of the terminal
Administrator - Display the total number of administrator enrolled in the terminal
Employee - Display the total number of employees enrolled in the terminal
Fingerprint - Display the total number of fingerprint templates enrolled in the terminal
Password - Display the total number of password stored in the terminal
Employee Log - Display the total number of transactions stored in the terminal
WorkCode - Workcode is a code being identified for excuse in attendance.