EVCO EPH4EXP Hardware manual - Manual (Page 83)

EVCO S.p.A. c-pro 3 | Hardware manual ver. 3.2 | Codice 114CP3E324
page 83 of 116
Networks /
CAN2 Bus (4)
MyNode 1 127 - - - 1 local (or of the controller) CAN node address
Networks /
CAN2 Bus (4)
Master - - - - - - - - - YES
enabling the operation as master in a CAN
network
YES = yes
Networks /
CAN2 Bus (4)
Baud - - - - - - - - - 20K
CANbus communication baud rate
20K = 20,000 baud
50K = 50,000 baud
125K = 125,000 baud
500K = 500,000 baud
Networks /
CAN2 Bus (4)
Timeout 1 60 s 5
remote (or with a device in the network)
CANbus communication time-out (after this
time without CANbus communication with a
device, it is excluded by the network)
Networks /
CAN2 Bus (4)
NetworkNode [ 1 ] 0
[ 32 ]
127
- - - [ 1 ] 99
address of a remote (or of a device in the
network) CAN node; example for [ 1 ] 2:
[ 1 ] = node
2 = node’s address
Networks /
CAN2 Bus
[ press button
RIGHT to
show it ] (4)
TSEG1 0 63 - - - 31 reserved
Networks /
CAN2 Bus
[ press button
RIGHT to
show it ] (4)
TSEG2 1 7 - - - 7 reserved
Networks /
CAN2 Bus
[ press button
RIGHT to
show it ] (4)
SJW 0 3 - - - 0 reserved
Networks /
CAN2 Bus
[ press button
RIGHT to
show it ] (4)
BTR(1) 1 15 - - - 15 reserved
Networks / MP
Bus (5)
Dev1 0 9953 - - - - - -
serial number of the first Belimo device (first
part of the label)