EVCO EPH4EXP Hardware manual - Manual (Page 60)

EVCO S.p.A. c-pro 3 | Hardware manual ver. 3.2 | Codice 114CP3E324
page 60 of 116
6.4. List of configuration parameters
6.4.1. List of configuration parameters of c-pro 3 hecto and of c-pro 3 hecto+
Submenu Parameter Min. Max. Unit Preset Description
Info PROJ parameter available in read only modality
information about the application project
(project, version and revision)
Info FW parameter available in read only modality
information about the firmware (project,
version, revision and subrevision)
Info HW parameter available in read only modality
information about the hardware (version,
revision, generic (G) or special (S))
Info SW parameter available in read only modality
information about UNI-PRO 3 (version and
revision)
Info SN parameter available in read only modality
information about the serial number and the
result of the productive test
Info MASK parameter available in read only modality
information baout the mask (it depends on
the builder’s coding system)
Info date and time parameter available in read only modality
date and time of the last compilation of the
application project
Parameters (1) AI1 - - - - - - - - - NTC
kind of probe analog input 1
PTC = PTC probe
NTC = NTC probe
0-20mA = 0-20 mA transducer
4-20mA = 4-20 mA transducer
0-5V = 0-5 V ratiometric transducer
0-10V = 0-10 V ratiometric transducer
PT1000 = Pt 1000 probe
Parameters (1) AI2 - - - - - - - - - NTC
kind of probe analog input 2
PTC = PTC probe
NTC = NTC probe
0-20mA = 0-20 mA transducer
4-20mA = 4-20 mA transducer
0-5V = 0-5 V ratiometric transducer
0-10V = 0-10 V ratiometric transducer
PT1000 = Pt 1000 probe