EVCO EVCSR338J9 - Manual (Page 41)

EVCO S.p.A. Vcolor 338 S | Installer manual ver. 1.2 | Code 144VC338SE124
page 41 of 50
15.4 Upload of the settings
contained in the configuration
parameters
To make the upload of the settings contained in the
configuration parameters, operate as follows:
1. Ensure that the device is switched off and that no
other procedure is in progress.
2. Plug in a USB flash drive containing a proper text
document called “param.txt” in the USB port of
the device and wait a few seconds.
3. Touch to select “Upload parameters”.
4. Touch the middle of the display: the upload of the
settings will be started.
5. To the end of the upload remove the USB flash
drive from the USB port of the device.
Operate as follows to exit the procedure before the operation
is complete:
6. Touch before point 4.
15.5 Download of the settings
contained in the configuration
parameters
To make the download of the settings contained in the
configuration parameters, operate as follows:
1. Ensure that the device is switched off and that no
other procedure is in progress.
2. Plug in a USB flash drive in the USB port of the
device and wait a few seconds.
3. Touch to select “Download parameters”.
4. Touch the middle of the display: the download of
the settings will be started.
5. To the end of the download remove the USB flash
drive from the USB port of the device.
Operate as follows to exit the procedure before the operation
is complete:
6. Touch before point 4.
Upload of the settings contained in the configuration parameters.
Download of the settings contained in the configuration parameters.