EVCO EVCSR338J9 - Manual (Page 23)

EVCO S.p.A. Vcolor 338 S | Installer manual ver. 1.2 | Code 144VC338SE124
page 23 of 50
8.3 Starting the cooking cycle
Operate as follows to start the cooking cycle:
1. Set the cooking cycle; see the paragraph 8.2
“Setting the cooking cycle”.
2. Touch : pre-heating will be started.
The opening and closing of the door causes the
passage to the first phase of the cooking cycle.
During preheat and during the cooking cycle, the display
shows the value of the variables affected by the process and
the relative setting.
To modify the settings; see the paragraph 8.2 “Setting the
cooking cycle”.
Touch:
- to open/close the vent
- to switch the environment light on/off
- to display the value of the process variables
and machine status.
On conclusion of the cooking cycle, the buzzer is activated for
the time established with parameter c0.
Operate as follows to extend the cooking cycle:
3. Touch .
4. Touch or within 15 s
5. Touch the middle of the display.
8.4 Stopping the cooking cycle
Operate as follows to stop the cooking cycle:
1. Make sure no procedures are in progress.
2. Touch for 1 s.
Starting the cooking cycle.
Pre-heat.
Extension of the cooking cycle.
Stopping the cooking cycle.