EVCO EVCSR338J9 - Manual (Page 34)

EVCO S.p.A. Vcolor 338 S | Installer manual ver. 1.2 | Code 144VC338SE124
page 34 of 50
14.3 List of configuration parameters
The following table illustrates the meaning of the device configuration parameters.
PARAM. MIN. MAX. U.M. DEF. ANALOGUE INPUTS
P0 0 2 - - - 0
probe type
0 = thermocouple J
1 = thermocouple K
2 = Pt 100 2 wires
P1 0 1 - - - 0
temperature unit of measurement (1)
0 = °C
1 = °F
P2 0 1 - - - 0
enabling the needle probe
1 = YES
P3 0 1 - - - 0
enabling of the steam reduction probe
1 = YES
CA1 -25/-50 25/50 °C/°F (2) 0 environment probe alarm
CA2 -25/-50 25/50 °C/°F (2) 0 needle probe offset
CA3 -25/-50 25/50 °C/°F (2) 0 steam reduction probe offset
PARAM. MIN. MAX. U.M. DEF. MAIN REGULATOR
r0 1 99 °C/°F (2) 5
work set-point differential (referring to the temperature detected by
the environment probe)
r1 0 r2 °C/°F (2) 0
work set-point minimum (referring to the temperature detected by
the environment probe)
r2 r1 999 °C/°F (2) 300
work set-point maximum (referring to the temperature detected by
the environment probe)
r3 r1 r2 °C/°F (2) 130
work set-point for factory setting (referring to the temperature
detected by the environment probe); see also r0
r4 0 r5 °C/°F (2) 0
minimum set-point at the core (referring to the temperature
detected by the needle probe)
r5 r4 999 °C/°F (2) 100
maximum set-point at the core (referring to the temperature
detected by the needle probe)
r6 r4 r5 °C/°F (2) 30
work set-point at the core for factory setting (referring to the
temperature detected by the needle probe)