Calling – Kenwood TM-451A User Manual
Page 88
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

CALLING
1 Tune to the prearranged frequency.
2 Press [DTSS] (1 s).
• "PAG" appears.
• Repeating this step toggles the Page function ON
and OFF.
3 Press [F], [DTSS] to select Code Select.
• The small Page memory "P" and "PAG" start
blinking.
4 Turn the Tuning control, or press microphone
[UP]/[DWN], to select the Page memory where the
desired Group code or Station code has been stored.
• Alternatively, if your microphone is equipped with a
DTMF keypad, the Page memory also can be
entered by using the keypad numeric keys. Press
the numeric key for the memory you want.
•
• If you have not stored the desired Page code in a
memory from 1 to 9, select memory 0 and store the
Page code at this time.
5 To restore the Display, press any button except [MR]
or [DTSS].
6 Press and hold [PTT].
• The Group code (or Station code) and your Station
code are transmitted.
... tj n c
!’■} i.Ji Jf u
■MMMiiiiimp /
1 S •
7 • OVEN
UliJ '
f
Pressing [PTT] automatically sends the Page data;
however, pressing [DTSS] while [PTT] is held down,
resends the data with the exception of European
versions using the Tone function.
Note:
► When Page is ON, Scan cannot be used.
► When Page is ON. choosing the VFO, the Call channel, or a
memory channel does not affect the Page status. Page remains
ON.
► When Page is switched ON while DTSS is ON, DTSS is switched
OFF automatically.
81