Rear panel, Confirmation before operation – Kenwood TM-451A User Manual
Page 33
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

CONFIRMATION BEFORE OPERATION
Before proceeding, run through the following checklist to
double check that your transceiver is ready to operate;
REAR PANEL
ANT (Antenna)
• Is the correct antenna actually connected?
• Is a lightning protector installed for a fixed station?
• Are interconnecting coaxial cables between the
transceiver, accessory station equipment and the
antenna connected?
• Are all cable connectors well-installed (including no
cold solder joints?) and screwed tight?
• Are coax switches set for the correct antenna?
CAUTION: DO NOT transmit without connecting an antenna or
dummy load to the ANT connector. The transceiver can fail.
DC 13.8 V (DC Power Cable)
• Is the power cable connected and locked in place?
(Do not turn on the transceiver or DC power supply
yet.)
DATA Connector
• Is a TNG connected correctly for Packet operation?
26