Programmable band scan, Setting scan limits – Kenwood TM-451A User Manual
Page 66
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Band Scan allows you to scan all frequencies from the
lowest frequency to the highest frequency on each band
that your transceiver is capable of receiving. The
currently selected frequency step size for each band is
used.
1 Press [VFO] to select VFO mode.
2 Select the band that you want to scan by pressing
[F], [REV].
3 Press [VFO] (1 s), and Scan starts at the frequency
currently displayed.
• The decimal starts blinking to indicate scanning is
in progress.
• The scan direction is the same as last used.
• The default direction is downward in frequency.
BAND SCAN
\
/
4 To reverse the scan direction, turn the Tuning control,
or press microphone [UP]/[DWN].
• Upward scan : Turn Tuning clockwise, or press
microphone [UP].
• Downward scan: Turn Tuning counterclockwise, or
press microphone [DWN].
5 To cancel Band Scan, press any key excluding the
microphone DTMF keypad keys.
PROGRAMMABLE BAND SCAN
This type of scan is similar to Band Scan except the
programmable aspect allows you to set scan limits within
the bands that can be selected by the transceiver.
■ Setting Scan Limits
1 Press [VFO] to select VFO mode.
2 Select the band on which you want to set the Band
Scan limits by pressing [F], [REV].
3 Press [REV] + POWER ON to enter Menu B, then
select Menu No. 61 {page 24}.
♦ The current upper limit appears.
4 Turn the Tuning control, or press microphone [UP]
or [DWN], to select the desired upper limit.
C n
«MF 1
1 • 7 • OVER
#
u t
59