Kenwood TM-451A - Manual (Page 84)

2 Select Menu No. 53 {page 24}.
• The current Delay Time appears.
71 C
-I Jf 11
MRF 1 > • 7 • oven
c :»
Jr Jr
3 Select a time value.
• The times available are 350 or 550 ms.
• Default: 350 ms
4 Exit Menu B.
Note:
► DTSS cannot be used with some repeaters.
y The delay time selected using Menu No. 53 also applies to
Message Playback Control.
MESSAGE PLAYBACK CONTROL VIA DTSS
Message Playback Control is available only on U.S.A.,
Canada, some European, and some General versions.
Check with your local KENWOOD dealer for specific
information. This useful function allows you to send a
specific pre-programmed DTSS code to your transceiver
that triggers the transceiver to switch to Transmit and
playback the contents Of its message memory.
Wherever you are, as long as you can transmit a signal
that can be received by your transceiver that has the
Message Playback Control function enabled, you can
retrieve your messages. Refer to "MESSAGE
RECORDING" {page 88} for more information on the
record/playback functions.
1 Press [REV] + POWER ON to enter Menu B.
2 Select Menu No. 72 {page 24}.
• The current Message Playback Control status
appears.
ric c
IM f
1 > a 7 • OVER
4 tj rj
O C
f4
4
> J(
it
l.'.id.'HI
z*
I c
Select a status.
• OFF: DTSS code will not initiate message memory
playback.
• ON: Message Playback is possible by sending
correct DTSS code.
• Default: OFF
Exit Menu B.
77