Kenwood TM-451A - Manual (Page 52)

Changing Call Channel Contents (Split)
1 Select the desired receive frequency and
associated data (Tone, CTCSS, DTSS, etc.) using
VFO mode or Memory Recall.
2 Press [F] to select Memory Storage.
• "F" and a memory channel number appear.
3 Press microphone [CALL] (1 s).
• " - +" appears.
4 Select the desired transmit frequency.
5 Press [CALL].
• The selected transmit frequency is stored in the
Call channel, and the previous mode is restored.
• Associated data selected in Step 1 such as Tone
status/frequency, the frequency step, and DTSS
status/code are not altered by this step.
However, Transmit Offset status and Reverse
status are erased.
CHANNEL DISPLAY FUNCTION
When this function is switched ON, the transceiver
selects Memory Recall and displays only a memory
channel number instead of a frequency. During
emergency drills and emergency communications, or
when participating in communications for important
events, channelized operations can increase operating
efficiency and maintain security of communications if
required.
With Channel Display ON, memory channels can be
selected using the Tuning control or microphone
[UP]/[DWN] as usual. Only memory channels
containing data can be selected.
1 Press [REV] + POWER ON to enter Menu B.
2 Select Menu No. 59 {page 24}.
• The current Channel Display status appears.
3 Select a Display status.
• OFF: Frequency Display
• ON: Channel Display
• Default: OFF
4 Exit Menu B.
45