Dc power cable connection – Kenwood TM-451A User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
2 Position the transceiver in the bracket to determine
the best viewing angle.
3 Insert and tighten the supplied hexagon SEMS
screws and washers. There are 2 screws and
2 washers supplied for each side of the bracket.
• Double check that all hardware is tightened to
prevent vehicle vibration from loosening the
bracket or transceiver.
Mounting
bracket
A
SEMS screws <
Stacking plate-'
liiSl
3EE1
Route the DC power cable supplied with the transceiver,
or an optional DC cable equipped with a noise filter,
directly to the vehicle’s battery terminals using the
shortest path from the transceiver. If using a noise filter,
it should be installed with an insulator to prevent it from
touching metal on the vehicle. It is not recommended to
use the cigarette lighter socket since some cigarette
lighter sockets introduce an unacceptable voltage drop.
DC POWER CABLE CONNECTION
Passenger compartment
I'Joise filter supplied
with PG-3B
Vehicle chassis
Power supply connector
........................
,Red ( + ) Fuse holders
with 20 A fuses
Black ( - )
Engine compartment
Double check cable
connections at the
battery to confirm
correct polarities
(Red ^ Positive,
Black ^ Negative).