beautypg.com

Storing dtss codes, Dtss and repeaters, Vstssfi /l – Kenwood TM-451A User Manual

Page 83: I\ vi 1, U u u

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

STORING DTSS CODES

You can store a DTSS code from 000 to 999 by using

the Tuning control or the microphone. Be aware that
audible DTMF tones from other transceivers near you

may be picked up by your MC-45DM/DME or TH-7
microphone element. If so, this could prevent the

following function from working correctly.

1 Press [VFO] to select VFO mode.

2 Press [DTSS] to turn ON DTSS.

• "DTSS" appears.

i , 4 U О c

r V I.J» Jl и

MRF 1 Э I 7

• oven

3 Press [F], [DTSS] to activate Code Select.

• "C" and "DTSS" start blinking.

\ ' /

n n

/VStSSfi

/L

U U U

1

— DTSS-

/ i\

Vi 1

SftRF

1

Э • 7 • OVER

4 Select a 3-digit number for the DTSS code by turning

the Tuning control or by pressing microphone

[UP]/[DWN].

• Alternatively, if your microphone is equipped with a

DTMF keypad, the DTSS code also can be entered

by using the keypad numeric keys. Press the 3
numeric keys in sequence for the code you want
and ignore Step 5.

5 Press [DTSS].

• The VFO mode is restored.

Note: If you press keys other than the microphone DTMF numeric
keys, or if you do not make the entry in Step 4 within 10 seconds,

the VFO mode is restored. Digits already entered will be stored.

DTSS AND REPEATERS

Pressing [PTT] transmits the DTSS signal after a short

delay. This delay helps avoid losing DTSS data when
using repeaters with long response times that may miss

receiving a portion of the DTSS code.

The delay time is 350 ms during simplex operation.

When using a transmit offset or a split frequency, you
can change 350 ms (default) to 550 ms.

1 Press [REV]+ POWER ON to enter Menu B.

76

This manual is related to the following products: