Kenwood TM-451A - Manual (Page 87)

Turn the Tuning control, or press microphone
[UP]/[DWN], to select Page memory A.
• Alternatively, if your microphone is equipped with a
DTMF keypad, the Page memory can be entered by
using the keypad numeric keys including [A]. After
entering the Page memory, the Page code stored in
that memory appears. "------- " appears when no
code is stored. Jump to Step 5 below.
О _____ __
IS«
'* c* I
¡ 4 4 . 3 S Q
— PAG-
I
4 Press [DTSS].
• Pressing [DTSS] shifts the transceiver between
Page code entry and
modes.
Page code memory number
• The large Page code "P" and "PAG" start blinking.
Select a 3-digit number (000 to 999) for your Station
code by turning the Tuning control or by pressing
microphone [UP]/[DWN].
• Alternatively, if your microphone is equipped with a
DTMF keypad, the Page code also can be entered
by using the keypad numeric keys. Press the 3
numeric keys in sequence for the code you want.
Jump to step 7 below.
fj- ^ J J
й i Ш i —PAO^- . \ f i —f _ / »1 \V
/ I' о О
13 17« OVER ^
^ t
Press [DTSS].
• This stores your Station code in Page memory A.
Select Page memory 1 to 9 by turning the Tuning
control, or by pressing microphone [UP]/[DWN].
• Alternatively, the keypad may be used as in Step 3.
Jump to Step 9.
О . • •
7 > ОУСЙ
« ILJ ».I n Г Г» » > tJr Jru
o' .
I — PAG H \\i'y ^ ' I I v'
Press [DTSS].
Select the 3-digit Group code or Station code that
you want to program,
• Again, the Tuning control or microphone can be
used to enter the code as in Step 5. Press
[DTSS].
• The keypad can be used as in Step 5.
• To store additional Group or Station codes, repeat
Steps 7 to 9.
____
c c
'л »-»£.< „
/1
1 Э ■ 7 * OVER
О t
* 1
• t j t j о к » 1r XJr Jru
s'l
,
— PAG Ч
10 To restore the Display, press any button except
[MR], [DTSS], microphone [UP]/[DWN], or the
microphone numeric keys.
You can use the Group code or Station code
immediately that was stored or selected last.
80