Kenwood TM-451A - Manual (Page 73)

► If using Sub 2 while Tone is ON, the ToneJCTCSS frequency must
be selected by turning the Tuning control or pressing
microphone [UP]J[DWNJ. You cannot select a new Tone/CTCSS
frequency by using [F], [TONE/CTCSS].
► To change the operating frequency while using Sub 2, first press
[VFO], or switch OFF the Tone/CTCSS and DTSS/Page functions
before attempting to change the frequency.
► If Sub 1 or Sub 2 is selected after both Tone/CTCSS and
Page/DTSS are ON, the Page/DTSS code is given priority. In this
case, press [TONE/CTCSS] to switch Tone OFF and then ON
again before attempting to change the Tone/CTCSS frequency.
^ When using Sub 2 with Page ON, you can change the Page
Memory after pressing [F], [DTSS]. When the small “P" begins
blinking, use the Tuning control or microphone [UP]/[DWN] to
change the Page memory. To lock-out the selected Page
memory, press [MR] or microphone [MR]. Pressing any key
other than Front Panel [MR] or microphone [UP]/[DWN]/[MR], or
simply waiting for 10 seconds, finalizes the new Page memory
selection.
Note:
Initiating the Display Demonstration mode causes the
following sequence to start:
• The normal Display appears with maximum illumination
after power is switched ON.
• Ten seconds after power ON, all Display segments
light, then the segments randomly disappear segment
by segment until the Display is blank.
• .A series of 3 different messages appear with each
message blinking on the Display for about 10
seconds.
This cycle repeats until the Display Demonstration mode
is deactivated. The transceiver can be used in the
demonstration mode, if desired. Using any buttons or
controls restores the normal Display immediately. If
there is no button or key entry, or Tuning control
adjustment, for more than 10 seconds, the transceiver
reverts back to the Display Demonstration mode.
Note: To exit from this mode requires either a Partial Reset or Full
Reset {page 46}. Switching OFF the transceiver power does not
cancel the mode. Also, this mode cannot be used with Channel
Display (page 45).
Press [DTSS] + POWER ON to activate Display
Demonstration mode.
DISPLAY DEMONSTRATION MODE
66