Vfo mode, Selecting frequencies ■ tuning control – Kenwood TM-451A User Manual
Page 39
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
VFO MODE
The VFO mode allows you to select operating
frequencies by using the Tuning control or the
microphone as explained under "SELECTING
FREQUENCIES" below.
Press [VFO] to select VFO mode.
• The currently selected frequency appears.
• If already in VFO mode, there is no change.
VFO mode must be selected when using the following
functions:
Select VFO
mode to use:
Page
Ref.
Select VFO
mode to use:
Page
Ref.
Programmable
Band Scan Limit
Select
59
Programmable
VFO Limit
Select
33
SELECTING FREQUENCIES
■ Tuning Control
Using the Tuning control is convenient when you are
within easy reach of the transceiver Front Panel, and
the frequencies to be selected lie near the current
frequency. The "fuzzy logic" design temporarily
increases the frequency step size as the Tuning
control is turned more rapidly.
Press [VFO] to select VFO mode.
Select your desired band by pressing [F], [REV].
Turn the Tuning control to select a receive
frequency.
Clockwise rotation increases the frequency one
frequency step at a time.
Counterclockwise rotation decreases the
frequency one frequency step at a time.
If you cannot select a particular receive frequency, the
frequency step size needs to be changed. See
"FREQUENCY STEP SIZE" {page 35} for further
information.
Note:
Frequencies can also be selected via the microphone
keypad. See "KEYPAD DIRECT ENTRY" {page 7i}.
32