Brother CM-2000 - Manual (Page 88)

Making Corrections
Ifyou wantto correct another character, you nnust move to that character and use [CODE]
+ [CORRECT] again.
If you wantto make insertions or deletions using manual correction, you can delete entire
words, character by character, and adjust the spacing ofthe new words using micro-spacing,
as with automatic correction,
4. Afterfinishing your corrections, use [INDEX], [R INDEX], [SPACEBAR] and [BKSP],
as required, to return to your original typing position.
Notes!
1, If [SPACE] is pressed after [CORRECT] has been pressed, the correction function
is cleared and the carriage will move to the nght one space.
2, You cannot use [RELOC] to return to youroriginal typing position after making manual
corrections.
Corrections in L/L, JUSTIFY And WP Modes
When typing on the display, correction is done on the display before the line is printed. In
WP mode you can, of course, correct any part of the document at any time.
Inserting Or Overwriting Text
When inserting extra characters or words in display typing, you don’t need to worry about
making space on the page for the new words, just turn on the INSERT function.
When replacingtextwith newtext,you don’t have to erase the old text first, you can simply
overwrite it if the INSERT function is turned off.
Inserting Text
If you miss out some words or characters it’s very easy to insert them as follows:
I. Make sure that INSERT is turned on by pressing [CODE] + [INSERT]. The cursor
will change from 1 to 0
,
to indicate that insert is turned on.