Brother CM-2000 - Manual (Page 140)

Searching And Replacing Text
This can produce unexpected results in REPLACE mode. For example, if you replace “hat”
with “cap”, you may end up with “ccapt”, “ccapter", and so on.
To avoid this problem, if the search string is a whole word or string of words, put a space
at the beginning and end, e.g. “_hat_“.
Now the search function will only find the word “hat". It will not find “chat” or “chatter”
because the string “hat” within these words does not have a space before and after it.
Hyphen Scan
Problems can arise with the word wrap function if the distance between the margins is
small, or when typing in languages such as German, which can have very long words. Since
the word wrap function automatically transfers any word that exceeds the right margin
onto the next line, excessively long blank spaces may appear, resulting in a poor layout
The hyphen scan function automatically detects an space that is wider than the hot zone,
and gives you the option of splitting long words between two lines.
The hyphen scan function means that when you first type your text, you do not have to
worry about hyphenating words to make the layout look good, apart from any permanent
hyphens that may be required. You can use the hyphen scan later to tidy up the layout
To use the hyphen scan;
1. Position the cursor at the beginning of the section that you wish to scan. If you wish
to scan the whole document, position the cursor at the start of the document
2, Call up the SEARCH menu as before, then press the [3] key to select H SCAN,
The hyphen scan function will search through the text until it finds a blank space widerthan
the current width of the hot zone,
While it is searching, the following message is displayed;
■=:iiAiORKING»«
In the following example, the text with the loose line is the following;
My brand neid Brother electronic
typeLuriter has many useful features