I lun s hnl-' f'ktbb rln= iu hyphen.qte, Pobltion 1 hnd press rtn- to hvphenrte, My brand nei.i.i brot-har elect-ronic typi – Brother CM-2000 User Manual
Page 141: Phen.qte, Pobltion 1, Rtn- to hvphenrte, H-=is ussful f«-st-ur'es
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Searching And Replocing Text
This is set with 40 characters between margins and a hot zone of 6 characters, so the word
"typewriter” wili not fit on the top line, making this line loose.
When a loose line is found, the following message will appear, together with the following
line of text.
1 s h-lErtl = L'J 1 r J»ri bUfiH
h-=iS
ussful f«-st-ur'es-
You will notice that a section of the text is highlighted.
The text to the right of the highlighted area is that part of the word that cannot fit on the
previous line because it would extend beyond the right margin.
The highlighted area and everything to the left of it could fit on the previous line ifthe word
was hyphenated. The highlighted portion of the word is that part that would be within the
hot zone if moved to the previous line.
3. If you wish to hyphenate the word, press [3]. The following message will appear.
i lUN S HNL-' F'Ktbb R l N = iU H
y
PHEN.QTE«
f'i-iSS Ffl^ny USSTUi TS-S't-Ur'SS"
4. Position the cursor on the character where you wish to break the word. In this case
the word typewnter should obviously be hyphenated as type-writer, so position the
cursor on the "w”.
^POblTION 1
h
ND
press
RTN- TO HVPHENRTE»
4. Press [RETURN], Everything before this character will be moved to the previous line.
(You won’t actually see this screen because the hyphen scan will continue).
My brand nei.i.i Brot-har elect-ronic typi
vji"' 1. "L-Si""' r ¡ay rfiai"
! u 1
*