Brother CM-2000 User Manual
Page 56
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Setting the Line Format
Each time you press the
[FORMAT]
key, the
FMT
display on the status screen will change
in the sequence; 1 —
—
^
4
—
^
5
—
^
1.
When the machine is first used, all five format memories are the same, so the format
functions displayed on the status screen will not change. Once you have changed the
contents of thefomat memories you will see these functions change as you cycle through
the five fomat memories,
The format memories are backed up. This means that the format information is not lost
when the machine is switched off. Also, when you switch the machine on again, the
selected fomat will be the one that you were using when you switched the machine off.
Format Memory Reset
ALT
CANCa
The fomat memories in your machine are factory set with the values mentioned earlier,
but it is quite likely that you will change them while using the machine. Should you wish to
restore the factory settings at any time, you can do this quite simply,
1. Select the format number you wish to restore to factory settings, using
[ALT] +
[FORMAT],
2.
Hold down the
[ALT]
key and press the
[CORRECT]
key.
3. The fomat memory will be restored to factory settings, and the following message will
be displayed:
AiFORMfiT IS CHfiNGED TO DEFAULT SETTING,
Changing A Line Format
Changing the contents of a line fomat memory to suit your own requirements is very
simple. Every time you make a change to one of the line fomat functions, the change is
automatically saved in the fomat memory that you currently have selected.
Ifyouhave some workthat requires frequent format changes, and otherworkthat requires
pre-defined fomats, it's a good idea to use fomat memory I as your “scratch” format
memory and reserve the other four memories for your fixed formats.
Howto change the various functions that make up the line format infomation is described
below.