Iujord3, Not h ound – Brother CM-2000 User Manual
Page 142
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Searching And Replacing Text
When the end of the document is reached, the following message is displayed:
■ ¿iuJORD3
A
NOT h OUND »
In orderto keep the same hyphenation rules as normal typing, the hyphen scan only allows
you to hyphenate words within the highlighted area. Obviously, you cannot hyphenate the
word at a position to the right of the highlighted ansa, because that would extend beyond
the right margin.
Similarly, in normal typing, the word wrap function will not split a word at a position to
the left of the highlighted area, since typing a hyphen at a position to the left of the hot
zone will not cause a carriage return, unless you break the line manually by pressing the
[RETURN]
key.
You may find there is no convenient place within the highlighted area at which to split the
word. In this case you may choose not to hyphenate it, by pressing [1] to continue the
hyphen scan, or you may decide to edit the line manually by pressing [2]. In this case you
must insert a hyphen manually and press the
[RETURN]
key to break the line.
Note that hyphens generated during a hyphen scan are ghost hyphens, and will disappear
if subsequent text editing or re-formatting means that the whole word will fit on the
previous line. Editing or re-formatting after a hyphen scan can also introduce loose lines,
so hyphen scan should be the last thing you, do before printing your document.