Brother CM-2000 - Manual (Page 193)

Troubleshooting
Maintenance and Troubleshooting
PROBLEM
1, Nothing works
POSSIBLE CAUSE
1. Typewriter not plugged
in
2. Typewrtternot
switched on
3. Cover not properly
closed
ACTION
Plug it in!
Switch it on!
Close it!
2, It still doesn't work! 1. Mains socket not
working
2. Blown fuse in plug
Check using another appliance
Check and replace if necessary.
Contact your dealer if problem
recurs
3. Characters do not print
or are faint
1. Daisy wheel inserted
incorrectly
2. Cassette ribbon has run
out
3. Cassette ribbon
inserted incorrectly
4. Impact setting too light
5. Paper thickness lever in
up position
Re-insert correctly
Replace
Re-insert correctly
Change setting
Push it down
4, Characters are missing 1. Daisy wheel has broken
petal
Replace daisy wheel
5. Correction does not
work
1. Correction tape has run
out
2. Correction tape
installed incorrectly or
back to front
3. Wrong type of
correction tape
Replace
Re-install correctly
Use correct type to suit the
cassette ribbon
6. Display Message
^RfiM DOiUN.
1. PAM memory fault Consult your dealer
7. Display Message
-:iRuM DOUjN.
2, Program ROM fault
Consult your dealer
8. Display Message
^CHECK PRINTER.
3. Faulty print mechanism
Consult yourdealer