Brother CM-2000 - Manual (Page 109)

Basic Wordprocessing
Adding Text To A File In Printing Mode
When you select an existing file for editing, it is normally edited in non-printing mode. It
is not possible to edit a file in printing mode, but you can add text to the end of a file and
print the new text at the same time, This can be useful if you want to add a postscript to
a letter, for example. You can print the postscript at the bottom of the letter and add the
extra text to the file at the same time.
To add text to an existing file in printing mode;
1, Make sure the page to which you wish to add the text is correctly positioned in the
typewriter.
2, Select the file to be edited from the WP INDEX screen.
3, Press [CODE] + FILE. The cursor will move to the end of the text, and you can type
in and print your additional text in exactly the same way as NEWFILE.P mode.
When you save the file, the text you added will also be saved.
Switching Back To TW Mode Or MAIN MENU
If you are in the middle of wordprocessing a document and want to type something else
such as an envelope or a short memo, you don’t have to abandon what you are doing.
Simply press the [TYPE] key to switch to TW mode, do your typing, then press the [TYPE]
key again to switch back to WP mode at the point where you left off.
If you want to quit wordprocessing and select another option, you can switch back to the
MAIN MENU from the WP INDEX screen by pressingthe [FILE] key. If you wish to switch
back to the MAIN MENU while creating or editing a document, you must first save your
file as discussed before, as you cannot select form typing or file management with a
document still open. After savingthe file, press the [FILE] key again to return to the MAIN
MENU.
Note!
You cannot use [TYPE] to switch from TW mode to WP mode unless WP mode
has already been selected from the MAIN MENU.