Brother CM-2000 - Manual (Page 57)

Setting the Line Foimat
Note!
Margins, tabs and the hot zone cannot be changed in line-by-line or justified typing modes.
You must select NORMAL or AUTO modes when setting these items.
Setting Line Spacing ALT
CMNCB.
Yourtypewriter offers you three choices of line spacing: single line spacing, one and a half
line spacing, and double line spacing. To select the desired line spacing, hold down [ALT]
and press the [LINE] key. Each time [LINE] is pressed, the L<* SP display will change in the
following sequence;
•1.0 -1.5 2.0 1-0
Single line spacing piaces I/6 inch of space between lines.
One and a half line spacing places I/4 inch of space between lines.
Double line spacing piaces I/3 inch of space between lines.
Note!
The factory setting of line spacing is 1.0.
ALT
CANCB.
Setting Typing Pitch
Yourtypewriter offers you four choices of pitch:
Pica, or lO pitch (lO characters per inch)
Elite or 12 pitch (12 characters per inch)
Micron or 15 pitch (15 characters per inch)
PS or Proportional Spacing
10, 12 and 15 pitch are fixed pitches, i.e. the print carrier advances a fixed distance after
typing any character. With proportional spacing, the distance the carrier advances after
typing a character depends on the actual character width. Therefore, the number of
characters per line in PS depends on what characters are typed, since you can get more
I's on a line than M’s.
For the purposes of setting margins and tabs, the nominal or average character spacing of
PS can be taken as 1
2
pitch.