Brother CM-2000 - Manual (Page 45)

Basic Typing
Express backspace
RELOC
EXPR
Holding down [CODE] ?^nd pressing the EXPRESS BACKSPACE key - [EXPR] will bring
the carriage immediately back to the left margin, When typing on the display, [CODE] +
[EXPR] moves the cursor symbol to the beginning of the line.
Micro backspace
BKSP
BS1
Holding down [CODE] and pressing the MICRO BACKSPACE key - [BS I] will move
the carriage to the left by I /120 of an inch. As the distance backspaced remains constant
at I /120 of an inch regardless ofthetyping pitch being used, backspacing in this case varies
by pitch as shown in the following table:
Pitch Spacing
10 I /12 of a character pitch
12 I /10 of a character pitch
15 I /8 of a character pitch
PS I /10 of a character pitch (nominal)
Thisfunction is useful in numerous different ways, including positioning a character or word
when the paper has been reinserted into the typewriter, or fortyping a character or word
into a limited space on the document. See “Insertions And Deletions" in the next section
for more information.
Relocation RELOC
EXPR
If you break off typing and move the carriage back along the typing line, using the cursor
and backspace keys, to make a correction, for example, yourtypewriter remembers where
the carriage was when you left off typing.
When you finish making corrections, the [RELOC] key returns the carriage back to your
original typing position.
Note!
Relocation is possible only while making corrections on the current typing line, or the
pr^ious line.