Inserting text at a stop code, Inserting text at a stop code -5, Stop codes – Brother CM-2000 User Manual
Page 157
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Printing Your Document
Stop Codes
Stop codes are used to stop printing of a document at a particular point so that text can
be inserted, for example, customizing a standard letter by inserting the addressee’s name
into it.
A stop code can be inserted at any point in the text by holding down the
[CODE]
key
and pressing the
[S CODE]
key, when a stop code symbol
(s)
will appear in the text.
When using stop codes, take care that the layout of the document is such that it can
accommodate the insertion of varying lengths of text at the stop code, without spoiling
the appearance of the document during printing,
For example, ifyouhavea I page document into which you wish to insert an address, make
sure that there is enough space on the page to accommodate ail the lines of the address
without the document becoming a two page document
Inserting Text At A Stop Code
When printing stops at a stop code, the following message will appear.
! Yr4
Tb.Y I
h
ND i“’RhL!i"S P
k
I N
i
Г и U U N l INUE =
Ч I Up UuDE> .>
You can type in yourtext on the page, then press
[CODE] + [PRINT]
to resume printing.
rif"= Н0Г !G0r'':=-Or!i
If the typewriter is set to
L/L
or
JUSTIFY
mode, you can type in the text on the display,
and print it a line at a time.