Brother CM-2000 - Manual (Page 58)

Setting the Line Format
To select the desired pitch, hold down [ALT] and press the [PITCH] key. Each time
[PITCH] is pressed, the PITCH display will change in the following sequence:
■10 -12 15 -> PS 10
lO pitch allows 120 characters to be typed per line.
12 pitch allows 144 characters to be typed per line.
15 pitch allows 180 characters to be typed per line,
The maximum characters per line in PS pitch is variable.
Note!
The factory setting of pitch is 10.
Margins And Page Length
The margin settings ofthetypewriterallowyouto determine the overall layout ofthe page.
Left and right margins define the overall width ofthe text and its horizontal position on
the page, Top margin (START SET) determines the vertical position ofthe text relative
to the top edge of the page, and page length (END SET) determines the overall height
of the text.
Preset Margins
When you first switch on your typewriter, the margins have been preset at the factory in
lO pitch and for single line spacing. If you change either of these, the preset margins will
vary, depending on the typing pitch and line spacing, as shown in the following table ,
Pitch Left margin Right margin
lO lO 75
I2 I2 90
IS IS I I2
Line Spacing Top Margin Page Length
l.O 6 Not set
1.5 4 Not set
2.0 3 Not set