Inserting the new cassette ribbon – Brother CM-2000 User Manual
Page 22
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setting
Up Your Typewriter
Inserting the new cassette ribbon
Remove the stopper from the nev/ cassette ribbon and turn the ribbon feed knob
counterclockwise to tighten the ribbon.
Now locate the lugs on the back edge of the cassette into the locating holes in the cassette
ribbon table, and slide the ribbon between the ribbon guides.
With the ribbon set between the ribbon guides, press the cassette down until it locks into
place. Turn the ribbon feed knob again slightly anticlockwise to tighten the ribbon.
Notes:
I. A window is provided in the cassette to allow you to check on the remaining amount
of ribbon.
This manual is related to the following products: