Manual buttonhole – Kenmore 385.160201 User Manual
Page 92
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Manual Buttonhole
(T) Stitch seiector:
@ Stitch width:
(3) Stitch length:
(?) Needle thread tension:
(5) Presser foot B:
D
(BH)
3 to 6.5
Blue zone
2 to 6
Buttonhole foot
To sew
If the diameter of the button is more than 1.0" (2.5 cm), a
buttonhole must be made manually as follows:
2] Turn the handwheel toward you to raise the needle to
its highest position. Raise the presser foot.
^ Set the stitch at “ []” by turning the stitch seiector.
® Attach the buttonhole foot [Bj.
(D
D
®
m
6.5
-
(.2)
)
W IDTH
HE®
0 Pull the buttonhole lever downward as far as it will go.
Slower the needle into the garment where the buttonhole
is to start, and lower the foot.
[6] Sew the front bartack and left row, then stop.
0 Click the buttonhole lever toward you.
] Sew the back bartack and right row, then stop the
machine at the starting point.
To cut the opening and to reset for sewing the next
buttonhole, refer to the instructions on page 78.
84