Overcast stretch stitching – Kenmore 385.160201 User Manual
Page 78
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Overcast Stretch Stitching
(T) Stitch seiector:
@ Stitch width:
(3) Stitch length:
(4) Needle thread tension:
® Presser foot A:
9
3 to 6.5
Gold stretch stitch position
2 to 6
Zigzag foot
This stitch is for sewing a seam with an overcast finish,
used when making swim wear, ski pants and other
garments which require stretch.
It is
WIDTH @
I
s.s.
LENGTH
MM
To sew
Piace raw edges of fabric to the “left” of the needle as
shown. Sew in a manner so that the needle pierces the
fabric very close to the outside edge. Or place the fabric
to allow a 5/8” (1.6 cm) seam, then trim the seam
allowance. Raw or worn edges of older garments can be
overcast to prevent further raveling.
Note:
Use a #11 blue stretch needle, which effectively
prevents skipped stitching.
Smocking
(T) Stitch seiector:
4
® Stitch width:
3 to 6.5
@ Stitch length:
Gold stretch stitch position
(4) Needle thread tension:
2 to 6
(5) Presser foot A:
Zigzag foot
(6) Presser foot F:
Satin stitch foot
Note;
Loosen the needle thread tension to make
gathering easier.
WIDTH ®
I
S.S.
LENGTH
m
V
ou
J
• To sew
(T) Wrong side (Bottom side) of fabric
(2) Knotted edge
Smocking is a delicate decorative treatment used on
children’s clothes or women’s blouses.
Choose a soft and lightweight fabric such as batiste,
gingham or challis. Cut the fabric three times wider than
the projected width. Set stitch length at "4” and sew rows
of straight stitches 3/8” (1.0 cm) apart across the area to
be smocked.
Knot the threads along one
edge®
. From the other
edge, pull the bobbin threads (bottom threads) to
distribute the gathers evenly and secure the threads.
Sew the smodiing stitches between the gathered rows.
Remove the straight stitches by pulling them out.