Kenmore 385.160201 User Manual
Page 72
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
® Stitch seiector:
@ Stitch width:
(3) Stitch length:
(4) Needle thread tension:
(5) Presser foot A:
© Presser foot C:
Overedge Stitch
1
3 to 6.5
1 to3
3 t o 8
Zigzag foot
Overedge foot
* When using an Overedge foot, make sure to set the stitch
width at 5 or more, otherwise the needle may hit the
overedge foot.
This stitch is often used as a seam finish to prevent fraying.
If using a zigzag foot, start overedging with the leftmost
needle position about 1/8" (0.3 cm) from the raw edge of a
seam. The right tip of the stitch should just clear the seam
edge.
For lightweight fabrics, use the overedge foot. To sew, line
the fabric edge up with the inner side of the brush holder
seam guide.
WIDTH @
LENGTH
MM
64