Kenmore 385.160201 - Manual (Page 84)

SECTION VII. BUTTONHOLE
Automatic Buttonhole
(T) Stitch selector:
(2) Stitch width:
(3) Stitch length:
(4) Needle thread tension:
® Presser foot R: [](BH)
3 to 6.5
Blue zone
2 to 6
Automatic buttonhole foot
(D
D
®
m
6.5 -
(.2)
I W IDTH
Preparation for sewing
® Groove
(2) Pin
Attach the automatic buttonhole foot R. Make sure the
groove on the foot holder catches the pin on the foot when
lowering the presser foot.
To sew
® Button holder
(2) Buttonhole lever
The buttonhole size is automatically set by placing the
button in the rear of the automatic buttonhole foot.
The button holder on the foot takes a button up to 1.0”
(2.5 cm) in diameter.
Make a test buttonhole on an extra piece of the fabric to
check your settings.
Use interfacing on stretch fabrics.
[T] Pull the button holder(T)to the back, and place the
button in it. Push it forward tightly against the button.
|T| Pull the buttonhole lever@down as far as it will go.
E
76