beautypg.com

Changing needle, To remove and attach the foot holder, Changing presser foot – Kenmore 385.160201 User Manual

Page 18

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Changing Needle

® Needle clamp screw
(f) Needle clamp

Q]Turn off the power switch.

Raise the needle to its highest position by turning the
handwheel counterclockwise, toward you, and lowering

the presser foot. Loosen the needle clamp screw (T) by
turning it counterclockwise. Remove the needle from the

needle damp@.

^ Insert a new needle into the needle clamp@ with the

flat side to the rear. When inserting the needle into the

needle clamp (2), push it up as far as it goes. Tighten

the needle clamp screw (T) firmly by turning it clockwise.

[

3

] To see if the needle is good, place the fiat side of the

needle onto something flat (needle plate, glass, etc.).

The gap between the needle and the flat surface should

be consistent. Never use a bent or blunt needle.

A damaged needle can cause permanent snags or runs

in knits, fine silks and silk-like fabrics.

To Remove and Attach the Foot Holder

(T) Thumb screw
(2) Foot holder
(3) Presser bar

• To remove

Remove the thumb screw (T) by turning it counterclockwise

with a screwdriver.

• To attach

Match the hole in the foot holder(2)with the threaded
hole in the presser bar (3). Fit the thumb screw(T)into

the hole. Tighten the screw (T) by turning it clockwise with

a screwdriver.

Changing Presser Foot

(T) Snap-on button (red button)
(2) Groove
(3) Pin

• To remove

Raise the needle to its highest position by turning the
handwheel counterclockwise. Raise the presser foot, and
press the red button® on the back of the foot holder.

• To attach

Place the selected presser foot, so that the pin(2) on the

foot lies just under the groove®)on the foot holder. Lower
the presser bar to lock the foot in to the place.

10