Kenmore 385.160201 - Manual (Page 48)

Topstitching
(T) Stitch seiector:
(2)
Stitch width:
(3) Stitch length:
(4) Needle thread tension:
(5) Presser foot A:
d) Presser foot H:
6 to 8
0
Red zone
2 to 6
Zigzag foot
Straight foot
NOTE:
When using the straight stitch foot, make sure to use the
center needie position, otherwise the needle may strike
the presser foot and possibly break.
(D
I I I
<|o c|j c|.
(4)
-Ml
0 -
WIDTH
LENGTH
Topstitching emphasizes lines of garments and keeps
seams and edges flat and crisp. Accent suits or blouses
with one or two rows of topstitching around the outer edges
of cuffs, lapels or collars. Lower the presser foot and keep
the edge of the fabric next to the right edge of the presser
foot.
Evenly guide the fabric along the edge to produce an even
row of topstitching 3/8” (1.0 cm) from the edge.
Quiiting
(T) Stitch seiector:
(2) Stitch width:
(D Stitch length:
(
4 ) Needle thread tension:
(5) Presser foot A:
(6) Presser foot H:
6 to 8
0
Red zone
2 to 6
Zigzag foot
Straight foot
NOTE:
When using the straight stitch foot, make sure to use the
center needle position, otherwise the needie may strike
the presser foot and possibly break.
Use the seam guide iines on the needle plate, and the free­
arm, to help determine the distance between quilting
stitches. The quilter will help keep the stitching line straight.
S Loosen the quilter holding screw.
Slide the quilter in the hole to the desired width and
tighten the screw.
[Zl Sew, guiding the quilter over the previous row of
stitching.
(T) Quilter holding screw
(2) Quilter
(D
Hole
(4) Distance
40