KEYENCE SL-R11E - Manual (Page 18)

Chapter 2 Functions
2-6
2
English ENGLISH
3. Refer to the table on page 2-5 and change the mode switches.
4. Close the switch cover, and use a screwdriver to tighten the screws to secure the cover. (The
recommended tightening torque is 0.08 N•m.)
5. Turn on the SL-R11E power, Refer to Chapter 5. Checklist ( ➮ page 5-1) and check the operation.
CAUTION
• The mode switch settings cannot be changed while the power is on. Be sure to
turn the power off before making changes.
• As shown in the previous table, there are two mode switches provided for each
function. Both mode switches must be on to turn the mode on. (Example: To
enable the start interlock function, mode switches 2 and 6 must be on prior to
supplying power.)
WARNING
• When finished setting the mode switches, be sure to close the switch cover and
tighten the screws.
• Mode switch settings shall only be set by the responsible personnel for using the
system. It must be made so that the machine operators cannot set the mode
switches.