Checkline TI-MVX - Manual (Page 5)

4) Press the OK key to complete the probe zero function, or ESC key to cancel
the probe zero function.
5) Remove the transducer from the probe zero disk, and proceed to the calibra-
tion section.
Note: The value that is displayed will change depending on the current velocity
setting in the TI-MVX. Disregard the number that is displayed. It is not important.
What is important is accurately performing the steps outlined above to insure
reliability of the probe zero calculation.
Known Velocity
If the material velocity is known, the user may
wish to simply enter the velocity number into the
TI-MVX, rather than have the TI-MVX calculate
the velocity value on using a know thickness. The
steps for entering the velocity are outlined below:
Using a Known Material Velocity
1) Press the MENU key once to activate the menu
items tab. Press the MENU key multiple times to
tab right and the ESC key multiple times to tab left
until the CAL menu is highlighted and displaying
the submenu items.
2) Use the UP and DOWN arrow keys to scroll
through the sub menu items until VELOCITY is highlighted.
3) Press the ENTER key to display the Digits Edit Box.
4) Press the UP and DOWN arrow keys to scroll the highlighted value.
5) Press the LEFT and RIGHT arrow keys to scroll the digit locations.
6) Repeat steps 4 & 5 until the velocity number is correctly displayed.
7) Press the OK key to set the velocity and return to the menu screen, or ESC to
cancel entering the velocity.
8) Finally, press the MEAS key to return to the measurement screen and begin
taking readings.
-5-
1) Press the MENU key once to activate the menu
items tab. Press the MENU key multiple times to
tab right and the ESC key multiple times to tab
left until the SETUP menu is highlighted and
displaying the submenu items.
2) Use the UP and DOWN arrow keys to scroll
through the sub menu items until SAVE is
highlighted.
3) Press the ENTER key to display the Save Setup
Parameters List Box.
4) Press the UP and DOWN arrow keys to scroll
the Name and Note parameters.
5) When the parameter to edit is highlighted,
press the ENTER key to activate the Alpha Edit
Box.
6) Use the UP, DOWN, LEFT, and RIGHT arrow
keys to scroll through the characters, the ENTER
key to select characters, and the CLR key to
backspace through the characters, until the
Name or Note fields have been edited.
7) Press the OK key to return to the Save Setup
Parameters List Box.
8) If both parameters will be edited, repeat steps 4 – 7.
9) Use the UP and DOWN arrow keys to scroll to and highlight SAVE SETUP.
10) Press the ENTER key to activate the Setup List Box.
11) Use the UP and DOWN arrow keys to scroll
through the setups until the target location to save
the Setup is highlighted.
12) Press the OK key to activate the confirmation
screen.
-76-