Checkline TI-MVX - Manual (Page 36)

Note: CHECK YOUR CALIBRATION! Place the transducer back on both calibra-
tion points. The thickness readings should now match
the known thickness locations. If they are not correct,
repeat the steps above.
Built in Material Selection
1) Press the MENU key once to activate the menu
items tab. Press the MENU key multiple times to tab
right, and the ESC key multiple times to tab left, until
the CAL menu is highlighted and displaying the sub-
menu items.
2) Use the UP and DOWN arrow keys to scroll
through the sub menu items until MATERIAL is
highlighted.
3) Press the ENTER key to display the list of Material Types.
4) Press the UP and DOWN arrow keys to scroll through the material list until
the appropriate material is highlighted.
5) Press the ENTER key to display the confirmation screen.
6) Press the OK key to select the material and return to the menu screen, or
press ESC to cancel the material selection.
7) Finally, press the MEAS key to return to the measurement screen and begin
taking readings.
-36-
Adjusting the Width using the Tabbed Menus
1) Press the MENU key once to activate the menu
items tab. Press the MENU key multiple times to tab
right, and the ESC key multiple times to tab left, until
the DISP menu is highlighted and displaying the sub-
menu items.
2) Use the UP and DOWN arrow keys to scroll
through the sub menu items until WIDTH is highlight-
ed.
3) Press the LEFT and RIGHT arrow keys to scroll
the value. When the correct width is being displayed,
proceed to step 8.
4) Alternatively, press the ENTER key to display the Digits Edit Box.
5) Press the UP and DOWN arrow keys to scroll the highlighted value.
6) Press the LEFT and RIGHT arrow keys to scroll the digit locations.
7) Repeat steps 5 & 6 until the Width value is correctly displayed.
8) Press the OK key to set the Width and return to the menu screen, or ESC to
cancel entering the Width.
9) Finally, press the MEAS key to return to the measurement screen and begin
taking readings.
Starting delay
The starting DELAY, or starting depth, is the value displayed on the bottom lower
left side of the display in both RF and RECT (Rectified) views. The DELAY will
also be represented in both the BSCAN and DIGITS (Scan Bar) views, as the
starting thickness depth. The starting depth is the minimum thickness value that
can be viewed on the display. In DIGITS view, the delay will only affect the start-
ing depth of the Scan Bar.
Note: Once the range is set, it remains the same for all the views respectively.
-45-