Checkline TI-MVX - Manual (Page 10)

2) Press the ENTER key to display the digits edit box.
3) Press the UP and DOWN arrow keys to scroll the highlighted value.
4) Press the LEFT and RIGHT arrow keys to scroll the digit locations.
5) Repeat steps 3 & 4 until the DELAY or WIDTH value is correctly displayed.
6) Press the OK key to set the DELAY and WIDTH value and return to the meas-
ure screen, or ESC to cancel entering the DELAY or WIDTH value.
7) Finally, press the MEAS key to return to the measurement screen and begin
taking readings.
Note: The DELAY & WIDTH can also be adjusted from the menu tab items.
However, using the hot menu keys is the easiest method.
RF RECTIFIED
-10-
10.6 Editing a grid
Once a grid has been created and saved to memory, the user can edit the
Comments or Increment Direction at a later time. The following procedures out-
line this process:
1) Press the MENU key once to activate the menu items tab. Press the MENU
key multiple times to tab right and the ESC key multiple times to tab left until the
DATA menu is highlighted and displaying the submenu items.
2) Use the UP and DOWN arrow keys to scroll through the sub menu items until
EDIT is highlighted.
3) Press the ENTER key to display the Edit List Box.
4) Use the UP and DOWN arrow keys to scroll through the Edit options until
NOTE or INCR. DIR is highlighted.
Note: If editing the INCR. DIR, simply use the
LEFT or RIGHT arrow keys to scroll NONE,
NORTH, EAST, SOUTH, or WEST. Proceed to
step 10.
5) Press the ENTER key to activate the Alpha
Edit box – Only used when editing the NOTE.
6) Use the UP, DOWN, LEFT, & RIGHT arrow
keys to highlight the appropriate alpha
characters.
7) Press the ENTER key to select a character
and advance to the next field of the Comments.
-71-