Yamaha SPX50D - Manual (Page 28)

NOTE: The program number/memory number assignments
made are stored in the BANK selected in the previous
MIDI CONTROL function. To program the program
change/memory number assignments for a different
BANK, return to the MIDI CONTROL mode, select the
desired BANK, then program the required assign­
ments.
/FOOTSWITCH MEMORY RECALL RANGE
/
The SPX50D permits memory selection via an optional Yamaha
FC4 or FC5 footswitch connected to the rear-panel MEMORY
footswitch jack. The fourth function accessed by the UTILITY
button — F.SW MEMORY RCL — permits setting the range of
memory location numbers that will be selected when the
footswitch is pressed.
F . S W MEMORY RCL
RANGE 51 TO 55
If, for example, the RANGE parameter is set to “51 TO 55” as
shown in the LCD illustration above, each time the footswitch is
pressed the next highest memory location will be selected until
the last number in the specified range is reached. After the last
number in the specified range, the first (lowest) number is se­
lected and the process repeated. Reverse sequences can be
programmed by entering the highest number in the range be­
fore the lowest, as shown below.
F . S W MEMORY RCL
RANGE 5 5 TO 51
In this case the selection sequence is : 55 “► 54 "■» 53 52 ■
51 “♦ 55, etc.
29