Yamaha SPX50D - Manual (Page 11)

USING THE COMPARE FUNCTION
/
ie COMPARE button is used while editing parameters in the
ftRAMETER mode to compare the sound of an edited pa-
imeter with that of the parameter before it was changed.
then the COMPARE button is pressed, the pre-edit parameter
jiue is temporarily recalled and the COMPARE button LED
ill light. Press the COMPARE button again to return to the
dited parameter value.
STORING EFFECTS
/
® Press the STORE button to store the edited effect in the
selected memory location. The title of the effect stored will
appear on the LCD (this may later be edited to create your
own effect title using the UTILITY mode EDIT TITLE func­
tion). The LED memory number display will stop flashing and
the stored memory location will become the active effect.
NOTE: You CANNOT store edited data to memory locations 1
through 50. If you attempt to do this the LCD will show
"*** READ ONLY*** MEM NO. 1—50”.
1 order to store an edited effect for later recall you need to do
le following:
) After editing the effect, select a memory location between 51
and 00 by first pressing the MEMORY button and then using
the A and V buttons. Do not recall the selected memory
location. If no data has been previously stored in the se­
lected memory location the LCD will read “ *** NO
DATA *** . ” If an edited program has previously be stored
in the selected memory location, its title will be displayed on
the LCD.
NOTE: Once an effect has been stored in an memory location
between 51 and 00, its parameters can be further ed­
ited in the new memory location. Such changes will be
lost if a different effect is selected and recalled, how­
ever, unless the STORE function is used to store the
changes. Changes may be stored to the current mem­
ory location number (51 — 00) simply by pressing the
STORE button.
12