Garmin GPSCOM 190 User Manual
Page 88
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
To attach the yoke mount to the control yoke:
1.
Loosen the lower knob.
2.
Slide the clamp over the control yoke shaft just behind
the control wheel.
3.
Tighten the lower knob securely.
4.
Make sure that the clamp is as close as possible to the
control wheel and check to make sure that the yoke
travel is not limited or hindered in any way by the yoke
mount.
5.
If it is necessary to change the direction of the clamp,
completely loosen and remove the upper knob, then
mate up the appropriate sets of teeth so the clamp
opens to the left or right (for conventional yokes), or
toward the instrument panel (for Baron or Bonanza
yokes or conventional control arms.)
6.
Tighten the upper knob.
7.
Loosen the clamp adjustment knob enough to slide the
clamp over the control yoke shaft or arm.
8.
Tighten the clamp over the control yoke shaft or arm
using the clamp adjustment knob.
The yoke includes a bracket holder which is used to
secure the GPSCOM 190 during flight and a bracket
extension which can be used to conveniently attach the
headset/microphone adapter.
APPENDIX A
Accessories 6-
Ifistalktion
Ueadset/Mkrophone/Power
Adapter
Power/Data
Cable
Lock/Unlock
Knob
Bracket
Holder