Gpscom 19b, Receher, Ittííiflíí^íhg the – Garmin GPSCOM 190 User Manual
Page 11: Welcome to the, The receiver, He given an
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
G
etting
S
tarted
Ittííiflíí^ÍHg The
Receher
Importantl
Make
sure
you charge the
Ni-Cad battery pack for
14
flours
before
using ^lour
GPSCOM 190 to ensure
optimum capacity and per
formance.
Note:
Wfien
cfiuiging the
battery pack,
turn
the unit
off to
ensure
a
fuH
charge.
Complete
instructions on charging
the
pack are
given on
page 89.
c
Welcome to the
GPSCOM
19B
fOFTUARE UEFt E.D4
COPYRIGHT 1995-9E
ORRHIH CORP
Welcome Ptrge
Initializing the GPSCOM 190 for First-Time Use
The first time you power up your new GPSCOM 190
is an important step in getting the best possible GPS per-
lormance
The receiver
must
he given an
oppoTtunify
to
collect satellite almanac data and
cstolilish ií5 present
position.
This initialization process takes approximately
3 to 5 minutes and is only necessary for first time opera
tion, after memory loss, or when the receiver has been
moved more than 500 miles from the last calculated posi
tion with the power off. Once your GPSCOM 190 has
been properly initialized, you should acquire satellites
and obtain a position quickly each time you power up.
Your GPSCOM 190 is shipped in the AutoLocate
mode, which is designed to let the receiver “find itself
without using its last known position (you don’t need to
worry about what lai/lon is currently displayed on the
position page, as the unit is not using that information to
calculate your present position.)
To power up your unit for first time use:
1.
Position the internal GPS antenna so it has the best pos
sible view of the sky (the internal patch antenna is locat
ed just above the keypad, marked by the embossed
globe.) if necessary, see Appendix A for instructions on
the installation of the GA 27 external GPS antenna.
2.
Turn the unit on by rotating the volume control
clockwise.
3.
Rotate the squelch control clockwise until receiver
noise disappears.
4.
Remain in the same location until the GPSCOM 190 has
calculated a position (the status page will be replaced
by the position page if no other buttons have been
pressed during acquisition).
Welcome Page and Database Configuration
The welcome page will be displayed while the unit
conducts a self test. Once testing is complete, the wel
come page will be replaced by the database page (see the
top of page 7), showing the database issue date. Updates
to the database are available from GARMIN or Jeppesen
on a subscription or one time basis.